Static Electricity Is The Killer Of The Electronics Industry

Electrostatic causes in many ways, such as contact, friction, and so on.

The process can be summarized as: contact → charge → transfer → charge layer formation → charge separation

Equipment or human body cause the electronics up to tens of thousands of volts or even hundreds of thousands of volts, even under normal operating conditions are often caused hundreds to thousands of volts.

The human body due to its own action and contact with other objects - separation, friction or induction and other factors, can bring thousand volts or even tens of thousands of volts of static electricity.

Static electricity is the result of positive and negative charge lose balance.

It is a kind of performance in the object with electric energy. The featuress are high potential, low power, small current and short acting time.

 

Electrostatic discharge causes  the most comment damage and serious electrostatic hazards are electronic components in electronic industry. It differentiates hard breakdown and soft breakdown.

1.Hard breakdown causes dielectric breakdown, burnout or permanent failure in one-time. 

2.Soft breakdown is caused by the performance degradation of the device or parameter indicator.

 

Friction electrification and human body electricity is the two major sources of harm in microelectronics industry. The damage is the accumulation of static electricity and electrostatic charge discharge. Therefore, the static electricity should be controled.

Static mechanical effects, the floating dust particles in the air will be adsorbed to silicon chip and seriously affect the quality of electronic products, therefore, clean working space must take anti-static measures.

Electrostatic protection work is a systematic project. Any omissions or errors, will lead to the failure. Must always prevent and precaution.

 

If it is the manufacture of electronic product or wafer parts. It is recommended to use anti-static suction cup. Avoid damage or short circuit during production or delivery.

CNL has been working with many wafer or electronic parts manufacturers to use anti-static suction pads and get a lot of improvement.

If there is any demand, please contact us  immediately, we can provide professional advice！